Solution

Control Panel & Drive System Integration

Control panel, MCC, VFD and soft-starter design and integration, with factory acceptance testing and on-site commissioning.

Engineering scene showing the equipment, control layer and site environment for this solution.

Pain points

Control panels are non-standard, poorly documented and hard to maintain
Drive selection and motor protection do not match the actual load
Panels are commissioned on site with little factory pre-testing

Meshox solution - scope of work

Control panel and MCC design and manufacturingVFD and soft-starter selection and integrationMotor protection, interlock and electrical schematic designWiring, labeling, point list and as-built documentationFactory acceptance test (FAT) before deliveryOn-site installation, power-up and commissioning

System architecture

Field Devices

Sensors

Instruments

Motors

Valves

Meters

Control Execution

PLC

DCS

VFD / Soft Starter

Control Panel

Supervisory

HMI

SCADA

Alarm

Remote O&M

Data Logging

Remote Monitoring

Reports

Applicable industries

Port Machinery & Bulk Material HandlingPower EnergyWater Treatment & Municipal UtilitiesPetrochemical Storage & Process ControlEnvironmental & Building ControlIndustrial Manufacturing

FAQ

Do you build panels to a specific standard?

Yes. We confirm the applicable electrical standard, environment rating and customer specification up front, then design wiring, protection and labeling accordingly and verify it during FAT.

Can you integrate panels with our existing PLC/SCADA?

Yes. Panels are designed with clear I/O point lists and communication interfaces so they connect cleanly to existing or new PLC, DCS and SCADA systems.

Have a control system, retrofit or integration project?

Start with a project evaluation. An engineer will review your requirements and propose a fitting control solution.

Talk to an Engineer →View Case Studies